WaveMon RF-8 and WaveMon RF-60 bring you maximum RF Safety with a dynamic range of 1000%
The WaveMon RF-8 and WaveMon RF-60 offer simultaneous alarms for instant and average values with a dynamic range of 1000%.
Regular personal RF monitors or exposimeters emit an alarm when they detect electromagnetic fields over permitted levels: this is known as instant values. The WaveMon RF-8 and WaveMon RF-60 also calculate average values.
What is the difference between these values? Instant values are the electromagnetic levels the sensors of the personal RF monitor detect. The average of these levels over a predetermined period of time are what we call average values.
Dynamic range of up to 1000%
The WaveMon is the only personal RF monitor with a dynamic range of up to 1000%. When it is detecting EMF, its sensors accurately measure, without saturating, spikes of up to 1000% over established limits. This allows the device to accurately calculate average values while reading large increases of levels in instant values.
Average values are extremely important for RF safety. In fact, international standards such as ICNIRP 2020, EU Directive 2013/35/EU, FCC, Safety Code 6, etc. are based on average values. Exposure to high RF levels for short periods is not necessarily dangerous for the RF worker; this is why limits are based on the average levels of exposure over certain time.
Thanks to WaveMon RF-8 and RF-60, the RF worker can keep working if safety limits are not exceeded, even if there are occasional spikes over 100% of instant values.
The previous diagram shows an actual WaveMon RF-60 measurement from a telecommunications tower. The RF levels rise in three peaks (corresponding with three antenna). While the instant values (blue line) large exceed 100%, the average readings (orange line) are well below 100% and thus ensure the RF worker exposure is within the established limits and can keep working. With a dynamic range up to 1000% (the maximum is 800%
WaveMon RF-8 and WaveMon RF-60 user-configurable alarms
WaveMon RF-8 and WaveMon RF-60 allow the user to configure different alerts based on instant and average values. This feature helps the user to avoid overexposure to EMF. The device will emit an alarm, vibrate and flash red LEDs to clearly alert the user.
⟶ Interested in the WaveMon? Please contact us. We will be delighted to answer any questions and to provide a demonstration.